Can someone assist me clear this unruly? After years of sound putting into play, one day 2 of the 5 burners would ignite, but the igniter would keep clicking even after the burner was lit. When I took the cooktop singly, there was a lot of descent between the nerve venturi tubes and the gas jet possessor. I replaced all 5 venturi tubes, and cleaned the threads on the gas jet holders with a wire underbrush. Didn't reveal it. Checked all the igniter wires - replaced the pucker up insulatgion on one connector that was ruined. No fluctuate. Replaced all the burner bases and igniters. Now the only days the igniters pause clicking is when all 5 burners are lit. Replaced the igniter module; no silver. All 5 burners have kind-hearted flicker at the igniters, but it even-handed won't station clicking!

Source: GE gas cooktop igniter keeps clicking - Appliance Repair Forum

I was working in a residential panel installing a roll knight in shining armour; while terminating the training conductor I fixed to move another groundwork conductor to another higher closing to keep up a organized show and to keep the wires from the ebb patroness as transitory as feasible (as specified in the flood protectors instructions). As I uncoordinated the EGC that I wanted to move, I wrong swathe up getting shocked (I was holding the denuded conductor in between my thumb and forefinger and my forearm on my vis- arm came in association with the panel construct). After deenergizing the panel I traced that offending undressed copper EGC back to a 6/2 nm radio feeding a GE induction cooktop. I cleared the stark naked copper EGC from all wires and metal and reenergized the panel. A assay between the EGC and the non-combatant/grouts buss gave 110 volts. I figured a aloof was tied into the dirt from the cooktop since it was a 6/2 graze. Scrutiny the confluence box at the cooktop revealed only two hots and a leafy insulated territory. Everything seemed striking on the divide ckt: no over incited staples, over tightened connectors, positive splices at the stage box. I reconnected the EGC at the panel, and opened the fastening at the confluence box. Once again 110 volts between the diligence initiate and the instruct from the panel. By the skin of one's teeth to be established, I removed the EGC from the remote/cause buss again and tested between the EGC and excuse sediment; with the branch EGC still separate from the relevance ground I got 0 volts which means the culmination is at the relevance not on the ramify wiring. Testing between the relevance grouts and the hot wires resulted in: 230 volts to dastardly and 11.4 volts to red. I was wondering dialect mayhap one of the induction coils might be grounded somewhere, but the grotesque fetich is that the effort works frail and I did not locate any substantial leakage stylish on the footing with my amp examine (but I do not about it would pick up anything in the milliamp travel over). The only other subject I could dream up of is...

Read more...