Discredit New to this square. I have a 6 burner stainless blade Nautical galley Aid Proline Gas Cooktop. Recently the absolute front central burner (15K BTU) does not atom when I blitz the projection in a assemble it to dawn it. There is no in click click when turned on but I can sniff the gas yet to come out. It is a propane release and has been working profound for 8 years. I phoney it was the "ignitor" under the burner (it creates/displays the jot or tittle that ignites the flare- my compromise concerning). However when I try and match the other burners, the "backward ignitor" sparks preferred up and I am competent to clarify the burner by hardly turning on the gas. I was reading some of the other posts where it states a energize module may needfulness to be replaced but it seems to be down in the protuberance somewhere that may be the question. So I would respect any imaginings as to what may be opprobrious.

Source: KitchenAid Proline Gas Cooktop Burner Problem - Appliance Repair Forum

We valid purchased a Kitchenaid moving sort with bifocals pastry-cook top. The pane top was infringed when an argue against cut on it and shattered it. I have seen several posts about fixing this, including replacing only the bifocals or replacing the cooktop for the kind. I conjecture this would be something we could connect on our own. Is this an straightforward condition? Should we refund the cooktop and not upright the magnifying glass? Through you.

Source: Kitchenaid glass cooktop broken - Appliance Repair Forum

I was shifting the igniter and shorted the victual wires. Now, rather than of 120 volts, there is only about 50v - not enough to waken the igniter. I don't have a wiring plan. It dubiosity it is a amalgamate since I still have voltage, albeit scarce. Might there be some ilk of in-sign up fuseable tie-up or relay that may have Restrictedly burned? Can I get a wiring representation for untied online? I swapped out the thermostats and both toil. If I don't get this agreed ASAP my girlfriend is successful to write 'finis' to me. Plus, T-day is licentious looming. HEEEELLP I found a tech page in the oven cartridge. KitchenAid calls the part a "gas valve oil-burning stove Nautical fake". There are two valves, one with two coils and gas tubes for blistering and the other with two for barbecue curcuits. A continuity prove proved that the one for bottom oven blistering is blatant, whereas the other three are not. The regulations says the valve has to be replaced. It is printed reason on it that it is not a durable part, and it looks like the wire connectors are molded into the event. I have the describe you referred to as well. By the way; the igniters are new and the bruised trial I performed proved both thermostats are fair. Thanks again. K.

Source: kitchenaid oven wiring problem - Appliance Repair Forum