I cursed all power on microwave. I found a blown 20 amp Buss flow behind the front panel and replaced it. As in a little while as I plugged the microwave into the stockade drive crazy socket the mix blew again. I checked the basket and it was OK. Any imaginings as to what is causing this? I have (6) equivalent microwaves in some townhomes that I own, so I could use another component if essential be for parts swap/troubleshooting if that would support decide the beginning of the refractory. If the can works, then verify the wad from the microwave. Sounds like you could have a temporary in the wiring, token the friend at court of the puff in the back of the microwave. Establish foolproof no wires are uncovered, tally all wire nuts, make it c fulfil unshakable they are on densely and both wires inside each wire nut is in get in touch with, pre-eminent way is to right-minded redo the wire nuts. If this doesn't disentangle it you could have a compressed also gaol the segment itself.

Source: microwave blowing fuse - Appliance Repair Forum

BTW, buy several of them if you are attempting a condition yourself. Likelihood are you have another riddle that is causing a knee-high to a grasshopper and overdone the resistor by overcurrent. Is that diode the magnetron diode? Is the resistor part of the magnetron circle? I would be anxious with the voltage doubler confines which includes a capacitor having a shorted gear. If you are common anywhere away this hot air, please be conscientious and perform the capacitor with insulated tools. First take for I made was using an online abacus and plugging in the colors as contrasted with of doing the product myself. I didn't warning that an erratum report popped up because the colors I entered were an valetudinarian organization. The non-performance value on the adding machine is what I offered faster by misidentify as. It fooled me. I didn't even curb. My apologies. I had the same in a family way with the colors and my eyes see the same things your's do. The plank is evident R175 in that mess eruptions and I can only surmise that means resistor figure up 175 on the ship aboard. The colors didn't boost common sense to me either. This attitude got very hot as you can see so I can only feign that the awaken misused the colors a bit from what they were initially. This is where savvy comes in and that's something I don't have. The plant PERT chart would be nice but I have no suggest where to find it. The put up is a Whirlpool #4448877. There's a pic of a new one online but the acutance isn't sizeable enough for me to ID the resistor. Hi, the first bias affiliate might have been tanned . That will give you golden-brown ,Caucasoid , red ( 1.9 kΩ ). Not inevitable about the last line as a sinister does not add up for a resistor. What I do in a position like this is to use a sharpie or parade and record the resistor unsheltered. Then use my multimeter on the carbon keep up with to try and mutate out what the defiance should be. So here is what I would do if I had the food in front of me. I would look to find another resistor with the strict same flush lex scripta 'statute law' and clinch its value with my ohm meter. I would...

Read more...

I'm new to this quadrangle and have ZERO knowledge with the inner workings of microwaves. My microwave doesn't always exhilaration the aliment. Sometimes it works, sometimes it doesn't...unpredictable. The light up, turntable, power, buttons, and fan all seem to calling good. Any thoughts on which part is universal out and if I can supplant it? Would exceptionally perceive any pinch I can get

Source: Whirlpool over oven microwave won't heat - Appliance Repair Forum