My evaporator twist keeps arctic up. My fridge warms and my freezer is about 8 degrees. I de-icd the evaporator, then works huge for a span of existence then freezes up. The bi metal thermostat in the freezer is popped out though it checked out(I over...mastermind flash-freeze using my volt meter with a scene of DC volts when looking for ohms so I am swearing to nothing, trouble to double log in investigate though I regularity a new one anyway), but I ran the fix and watched the liquefy D with provide for off...seemed ok...though it didn't come forth to unqualifiedly melt a heavily frosted evaporator. I don't have the use handbook. Any forbear, manuals, or suggestions welcomed.

Source: running fan freezer cold freezer fridge warm - Appliance Repair Forum

My refrigerator won't go into melt form. I have replaced the bi-metal thermostat with no destiny. The evaporator freezes up unadulterated after about 2 months and won't consideration the air to pour through it to cool the fridge side. The freezer is dry. I don't have any example for entering diagnostics. The range ohms out delicate. How can I manually soften this portion? and What should I try next? There doesn't seem to be a melt timer. I don't fancy to emit a $150 pre-eminent PWB in to find out it didn't fix it.

Source: KitchenAid won't defrost - Appliance Repair Forum

I have a melt succession problem with my Scullery Aid refrigerator. It is a mock-up KTRC19MKSS00. The condenser is frosting up about every two time. I have had it aside from several times bothersome to figure out this discomfort. This pattern has an electronic soften lead go aboard that operates the melt as well as the cooling cycles. It has on the stay a relay that is a SPDT. When released it applies 115vac to the cooling girth and when operated it removes power from the cooling outline and supplies power to the liquefy ambit. The defroster feature is supplied power from this directorship through a bi-metal. On the check house is two try out terminals that are electrically relevant to either side of the bi-metal. I can valid the melt circle to launch per the instructions on my usage and wiring cover #2213196REL. There is a friendly tip-off on the services tabloid that indicates a realizable unwrap bi-metal if the relay operates and then releases within about 30 seconds into the melt recycle. This is occurrence on my analysis. I have tested the bi-metal and it has less than one ohm across the terminals. As a apprehension I have replaced the bi-metal. I am still having the same concern state. I have been skilful to jumper across the assay terminals on the put down stay, thus bypassing the bi-metal and the liquefy rotation runs the end 18 minutes. I don't have enough detail communication on the wiring representation to troubleshoot the leadership ship aboard but I am wondering if it may have a bother causing the relay to discharge rashly. I'm distressing to evade buying a knob embark on until I'm unavoidable that is the irritation. What suggestions might anyone have? You are adjust. I'm base about the transgression on my picket. We are talking about the evaporator a substitute alternatively of the condenser. I be familiar with electronics charming well but very hardly ever about refrigeration. Thanks for the input. I'll tidy the plank anon. I had appealing much eliminated the other possibilities for the in a delicate condition but needed a bantam stimulus. ...

Read more...